How to get best results from Decals/Stickers.
For proper adherence/bonding, all surfaces should be considered as dirty and should therefore be cleaned prior to any vinyl application. Household surface cleaners, such as Windex, are acceptable; however, it is recommend a 2-to-1 mixture of water and isopropyl alcohol. After thorough washing, wipe the surface dry with a clean, dry, lint-free cloth.
Air and surface temperature must be above 55 degrees Fahrenheit for the application of the vinyl.
Apply the vinyl using the following steps:
Temperature is very important when working with vinyl - too cold and the vinyl is too brittle to handle and cut easily and may shear or rip when applying. Too hot and the material will adhere too aggressively trapping air bubbles and will deform too easily to allow manipulation.
Spray the surface with water or application fluid
Note: do not spray water or application fluid when using reflective vinyl. Reflective vinyl should be applied on a dry surface. Place the left side of the decal down on the surface, with the application tape still intact, squeegee the decal to the surface by applying pressure with smooth even strokes. Start at the middle of the decal and work your way out to the left.
Note: Before you squeegee, make sure there are no wrinkles in the decal or application tape.
It is a good to wait just a couple of minutes before you remove the application tape.
This allows the application fluid to begin drying and will prevent the decal from trying to come up. Once it is adhered to the surface, squeegee the entire decal a second time. Then carefully peel the tape off the entire decal.
It is possible for there to be some small bubbles throughout the decal.
These bubbles will leave by themselves within a few weeks. If you have any major, bubbles you can eliminate them by carefully heating the area with a hair dryer or heat gun, then puncturing them with a needle and applying pressure with your thumb. Note: You can do more damage than good by chasing the smaller bubbles. They will leave themselves as the vinyl breathes and the application fluid evaporates.
Still if you have any problem pls mail us we will be happy to give you more brief regarding same.
warstik@gmail.com
You can also download the pdf format file by clicking the below link in which we have shown with picture .
